readme update

This commit is contained in:
BitMaker 2023-10-01 10:54:30 +02:00
parent f6054ee66c
commit c93e884b51

View File

@ -75,7 +75,7 @@ Update NerdMiner firmware following same flashing steps but only using the file
1. In extreme case you can "Erase all flash" on ESPtool to clean all current configuration before uploading firmware. There has been cases that experimented Wifi failures until this was made. 1. In extreme case you can "Erase all flash" on ESPtool to clean all current configuration before uploading firmware. There has been cases that experimented Wifi failures until this was made.
1. In case of ESP32-WROOM Boards, could be necessary to put your board on boot mode. Hold boot button, press reset button and then program. 1. In case of ESP32-WROOM Boards, could be necessary to put your board on boot mode. Hold boot button, press reset button and then program.
### NerdMiner configuration ## NerdMiner configuration
After programming, you will only need to setup your Wifi and BTC address. After programming, you will only need to setup your Wifi and BTC address.
#### Wifi Accesspoint #### Wifi Accesspoint
@ -181,4 +181,6 @@ With the USB-C port to the right:
### Donations/Project contributions ### Donations/Project contributions
If you would like to contribute and help dev team with this project you can send a donation to the following LN address ⚡teamnerdminer@getalby.com⚡ or using one of the affiliate links above. If you would like to contribute and help dev team with this project you can send a donation to the following LN address ⚡teamnerdminer@getalby.com⚡ or using one of the affiliate links above.
If you want to order a fully assembled Nerdminer you can contribute to my job at [bitronics.store](https://bitronics.store).
Enjoy Enjoy