update readme add tripple click option

README.md

@@ -41,6 +41,8 @@ Every time an stratum job notification is received miner update its current work
 - ESP32-WROOM-32, ESP32-Devkit1.. ([Aliexpress link*](https://s.click.aliexpress.com/e/_DCzlUiX))
 - ESP32-cam [Board Info](https://lastminuteengineers.com/getting-started-with-esp32-cam/)
 
+* affiliate link
+
 ### Flash firmware
 #### microMiners Flashtool [Recommended]
 Easyiest way to flash firmware. Build your own miner using the folowing firwmare flash tool:
@@ -92,7 +94,7 @@ After programming, you will only need to setup your Wifi and BTC address.
   "Timezone": 2  
 }
 1. Insert the SD card.
-1. Hold down the "reset configurations" button as described below or power up without settings in your nvmemory.
+1. Hold down the "reset configurations" button as described below to reset the configurations and/or boot without settings in your nvmemory.
 1. Power down to remove the SD card. It is not needed for mining.
 
 #### Pool selection
@@ -115,6 +117,15 @@ Other standard pools not compatible with low difficulty share:
 | eu.stratum.slushpool.com | 3333 | https://braiins.com/pool |
 
 ### Buttons
+
+#### One button devices:
+
+- One click > change screen.
+- Double click > change screen orientation.
+- Tripple click > turn the screen off and on again.
+- Hold 5 seconds > **reset the configurations and reboot** your NerdMiner. 
+
+#### Two button devices:
 With the USB-C port to the right:
 
 **TOP BUTTON**
@@ -162,6 +173,6 @@ With the USB-C port to the right:
 - [ ]  Add support to control BM1397
 
 ### Donations/Project contributions
-If you would like to contribute and help dev team with this project you can send a donation to the following LN address ⚡teamnerdminer@getalby.com⚡ or use the affiliate links(*) above.
+If you would like to contribute and help dev team with this project you can send a donation to the following LN address ⚡teamnerdminer@getalby.com⚡
 
 Enjoy

src/NerdMinerV2.ino.cpp

@@ -58,6 +58,7 @@ void setup()
     button1.attachClick(switchToNextScreen);
     button1.attachDoubleClick(alternateScreenRotation);
     button1.attachLongPressStart(reset_configuration);
+    if(button1.getNumberClicks() == 3) alternateScreenState();
   #endif
 
   #if defined(PIN_BUTTON_1) && defined(PIN_BUTTON_2) //Button 1 of two button device

src/wManager.cpp

@@ -76,7 +76,6 @@ void init_WifiManager()
     // Check if button2 is pressed to enter configMode with actual configuration
     if (!digitalRead(PIN_BUTTON_2)) {
         Serial.println(F("Button pressed to force start config mode"));
-        reset_configuration();
         forceConfig = true;
         wm.setBreakAfterConfig(true); //Set to detect config edition and save
     }