diff --git a/README.md b/README.md
index 0b91f7d..7473876 100644
--- a/README.md
+++ b/README.md
@@ -71,29 +71,31 @@ Update NerdMiner firmware following same flashing steps but only adding 0x10000_
 ### NerdMiner configuration
 After programming, you will only need to setup your Wifi and BTC address.
 
+#### Wifi Accesspoint
+
 1. Connect to NerdMinerAP
     - AP:   NerdMinerAP
     - PASS: MineYourCoins
 1. Setup your Wifi Network
 1. Add your BTCaddress
 
-OR
+#### SD card (if available)
 
-1. Your board and firmware are SD card enabled.
 1. Format a SD card using Fat32.
 1. Create a file named "config.json" in your card's root with the following structure. Adjust the settings to your needs:
-{
-  "SSID": "myWifiSSID",
-  "PW": "myWifiPassword",
-  "PoolUrl": "public-pool.io",
-  "PoolPort": 21496,
-  "BtcWallet": "walletID",
-  "Timezone": 2
+{  
+  "SSID": "myWifiSSID",  
+  "PW": "myWifiPassword",  
+  "PoolUrl": "public-pool.io",  
+  "PoolPort": 21496,  
+  "BtcWallet": "walletID",  
+  "Timezone": 2  
 }
 1. Insert the SD card.
 1. Hold down the "reset configurations" button as described below or power up without settings in your nvmemory.
 1. Power down to remove the SD card. It is not needed for mining.
 
+#### Pool selection
 
 Recommended low difficulty share pools: